Hello, I am trying to get a remote user to always have the same IP address when they connect to the VPN. Our group is simply pulling from an address pool 10.10.10.1-10.10.10.254. I could not find a way to get a static IP so I created another group...
Hello, I downloaded the client for mac osx and ran the install, it installed correctly and I rebooted. I then tried to run the client and I got an error saying that I probably need to start the service. I figured that should happen on reboot, a...
Hello I am using VPN client Version 4.0.5 to connect to a VPN concentrator 3000 series. I have users using VoIP from their homes and sometimes they will lose network connection which brings down their VPN and IP phone. This can happen when they are...
Thank you for the reply. I found where you are talking about. However my VPN client is setup to use group authentication, and I have a group for our company. Then that group uses NTdomain authentication and users put in their domain username/pwd ...
Thank you very much for the reply, I have seen this before but wasnt sure if this was the best method for what I was trying to accomplish. I have my ini setup and verified auto initiate is enabled through the command prompt. I am using a verizon wi...