Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I would like to know what are all possible reasons for wireless clients to get disconnected from LAP (to WLC) solution. We have WAN (MPLS) between LAP and WLC and on the remote site (where we only have LAP, since WLC is in central site) we ...
Hello there,I have following situation.network---wlan controller4402----FW1---MPLS---FW2---Access points----networksI can see very big amount of fragmented packets coming to FW2 and getting dropped in one moment. After those packets get dropped, acce...
Hello,This is continuation of my previous posts here. I did a lot of research, but I have a problem finding one thing: Is auto-negotiation mandatory on 1000BaseX (i.e 1000BaseSX) interfaces? (in other words, should every 1000BaseX interface support a...
Let me post the same issue to the Optical forum too:Hello,Here's the problem.There's one Juniper SSG 20 firewall with JX-SFP-1GE-SX multimode fiber interface (850nm) (which I can control) and I have to connect it to Cisco 4506 switch which has WS-X43...
Hello,Here's the problem. There's one Juniper SSG 20 firewall with JX-SFP-1GE-SX multimode fiber interface (850nm) (which I can control) and I have to connect it to Cisco 4506 switch which has WS-X4306-GB module and WS-G5484 GBIC interface (also mult...
Hello,I find out the answer couple of days ago. I totally forgot about this post :)). Finally, problem was in fragmented packets that were lost in defragmentation in the devices in the middle (between Cisco WLC and LAPs)I found out very annoying fact...
Hello again,If anyone has ever implemented LWAPP over a WAN with proper QoS, any advice would be more than helpful. I would like to learn from someone with plenty of hand on experiences when dealing with the scenario similar to the one that I have. I...
Hello Wynneit.Thanks for your quick response:) here's another rating (I also found very useful your post about which port is used for which channel so I had to rate that one too)I found 100ms information... to bad that Cisco doesn't put sentences lik...
Hello,If my assumption from previous post was correct... what would be your advice on what to put guarantied bandwidth for control channel? If I have 20Mbps link for example, what would you put as something that's guarantied for LWAPP 12223 control c...
Hello Wynneit,So you think if RTT exceeds 100ms, LAP should be disconnected then? If this is true, that can be an explanation why LAP is getting disconnected in the first place.Now I only have to figure out how this RTT is calculated. Is it calculate...
