Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello !I have a situation and I was hoping to find the solution among you guys,well, I have two access points type: "Cisco aironet 1240AG series 802.11g"and i want to make them connect to each other with wireless, i looked in some groups, and i found...
Hello !
I have A question:
What is the difference between :
-Root Bridge with Wireless Clients -Non-Root Bridge with Wireless Clients
I want to change my AP to non-root bridge but it refuses it give a error message as show bellow
Hello
Good morning ,
I have a Access point model 1242AG , it's configured in station role to be a root bridge,
the issue is when I try to change the station role to no-root bridge with wireless clients , it gives me a message "ERROR :'set infr...
Hello everyone ,
The problem is solved
All I had to do is open the GUI and copy the configuration from the other terminal and past it into the specific AP , after that you do a check then you will find all the configuration including the role stat...
Yes I do have a static ip address for the both of them,
When I try to select the the non-root bridge from the root bridge AP, it does not allow me , it says that I have to set the Infrastructure SSID'must be configured inorder to set the 'role in r...
I have 2 AP one with root bridge and the other with non-root bridge, the situation here, is I want to revers the roles , but it gave a error message as a mentioned earlier
