Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
First of all I want to tell you a bit about the system that i get the error message:A 1760 with FXOs. Calling party redirected to DN YYY (CTI DN) to IVR according to plar configuration under the FXO ports and then if no internal DN entered by the cal...
Hi;You may try to use a # sign at the end of the pattern -7xx#- if it is suitable for the users. By this way the users will not have to wait for 10sec -that is the interdigit timeout- but have to press # instead.Hope this helps.
Hi;I guess you are missing relating time schedules with partitions.As you know, any pattern including DN, hunt pilot etc. must be in a partition -even in partition none-; if you relate a partition with a time schedule then during this period that par...
call-forward noan directory-number timeout seconds[Configures call forwarding to another telephone number for calls that are not answered before the timeout interval expires.?timeout seconds?Sets the waiting time, in seconds, before an unanswered cal...
Please check the following commands, especially "allow connections from h323 to sip":telephony-servicecall-forward pattern .Tvoice service voipallow connections from h323 to sip
Check that link first please: http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00806a7fe8.html Sample config of CME&SRST from CCO:The following example shows a Cisco Unified CME system at 10.1.68.78 that...
