Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm not good at ISO or routing so forgive me...I have a 2811 with dual T1's and two available ethernet ports. I want to assign one to our LAN (the port the firewall plugs into) and one for a computer that sits out by itself for a customer. I have a r...
I have five offices all running 2811 routers and ASA 5510 firewalls. Each office is connected by bonded T1's using MPLS. The ASA is configured with a WAN, DMZ, and LAN ports. I want the users on each LAN to be able to connect to other offices DMZ's. ...
I'm a noob so keep it simple for me. I'm not good at the commands.I want to lock down my PIX 501 (v.6.2) by doing the following:Disable all incoming traffic except if initiated by someone on the inside and https access to one web serverBlock all outg...
I have two PIX 501's that are connected via VPN. I want to create one client connection so that as the admin I can get into the network if needed. What do I need to do on the PIX's to set up the client connection. I'm noob so you'll have to dumb it ...
Public meaning the external IP block or the IP's used on the ISP's MPLS private WAN? Not to be blunt ceclark, but your reply is vague and doesn't really help. I can get myself through basic stuff but need help with what is the BEST way to have users ...
I've tried from a couple of PC's, the netware servers, and the PIX...nothing. I think I may wipe this PIX andstart up (initial config and all). I don't have any other routers or firewalls. When I did a show route I saw xxx.xxx.xxx.64, but it should b...
My login won't allow me to use the tool (why does Cisco require a login for everything?!).I know ZERO about IP telephony so you just blew my mind. 1). Best estimate for active calls will be 20% of the people at the office at any one time. (We have di...
