Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,There was "modem-pool" command on AS5300 routers which may be used to group the modems. In this way when a specific number is dialed , the modem on the configured group on the access server was get it. I couldn't see the same command on AS5350 cha...
Hi everybody,On 2 access servers I configured Stack group binding protocol to operate MMPPP. If I use the same username for 2 connection , there is no problem. I can see MMPPP bundle is created on only first access server. Client operates perfectly. ...
Hello Everyone,My case is about redirect of a voice call. I am using only routers. I want if the voice port of other router is full or beeing used , an additional call needs to be redirected. I tested this case. If IP network is unreachable redirect ...
Hi,I would like to make some additions to the answers given. You know L1 areas don't see the L2 routes and the routes of other L1 areas. L1 areas are like totally stub areas in OSPF. An LSP to be established, there should be a label in the cef table ...
Hi,In this case you actually have 2 options : frame mode or cell mode. In both cases flowing packets will be fragmented into cells on the forwarding plane. So there is no difference on that plane even if there is no ATM switch between 2 routers. The ...
HiI am not sure the exact platform that feature is supported. But RSVP hello packet is optianal in RFC and this is used in MPLS traffic Engineering part. Thats why this feature probably is in the high end platform and may be in SP edditions which sup...
Hi,ADSL is configured like ATM. So you can control a user traffic giving the ATM service parameters to his ATM VC. This is valid if user PVC comes upto your router. But some DSLAMs can also terminate PVC and directs user traffic to the Access concent...
Hi,RFC 2328 says"If the state of the interface is Loopback, add a Type 3 link (stub network) as long as this is not an interface to an unnumbered point-to-point network. The Link ID should be set to the IP interface address, the Link Data set to the...
