Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
New switches were installed in a site. For about 3 weeks everything on the Windows domain worked correctly. DNS, DHCP, WINS, and so on. Now, the client PC's can't reach the DHCP server which is in a main site far away from the secondary sites. Th...
I have multiple switches at different locations ( 16 ) I was hoping someone could explain wheather to leave "All" switches in vtp server mode. I have not created any vlans and I don't think that I will at this present time. So the question is, wil...
Is it possible to trunk two 2950 switches? I can trunk one of the 2950 to a 3650 with no problem. When I try and trunk a 2950 with another 2950....That's a no go....
Yes, I think there is some type of issue trying to trunk two gigabit interfaces between the 2950 switches. I just made fa0/48 a trunk to the Gi0/1 of the other switch. Problem solved.... Thanks for your input...
All this looks correct. Now here is the situation. All switches are being implemented are set for server. No VTP domain on any switch. It's kind of funny because I can trunk between two different model switches with none of the VTP configurations...
The IOS IS 12.1 Used the "switchport mode trunk" command Also, tried swapping cables from a 3560 and 2950 trunk. Trunk came back up, but 2950 to 2950 trunk is still dead. I'm lost.... I read something about "EtherChannel"...?
I can trunk to a 3650, but not to another 2950..Output below..GigabitEthernet0/2 is down, line protocol is down (notconnect) Hardware is Gigabit Ethernet, address is 0014.6a35.e572 (bia 0014.6a35.e572) MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, ...
