Hello!I try to configure RSPAN on 2960 switch. But nothing sends to the destination switch. When I try to do the same in 2950 everything works fine. Here is the configuration of the 2960:----------------------CUS_48ports_2#sh run vl 100Current config...

Hello!I have a problem with traffic duplication. There is a traffic flow between server 192.168.1.1 and 192.168.1.2 (both directions). But I see traffic from 1.1 to 1.2 on all the servers in the same VLAN and net on this switch (2950G)! Traffic from ...

Hello!On PIX 515E I need access from a real IP x.x.x.x (outside interface) to inside IP 10.1.1.2 (inside interface) without NAT - for test purposes. When I try to access from the real IP x.x.x.x inside IP 10.1.1.2 PIX sends error messages to syslog: ...

Hello!Our Cisco 4503 always when reboots comes to the rommon, but we neet it to boot IOS automatically. Configuration register is 0x102, but it doesn't help. We configured "boot system flash cat4000-i9s-mz.122-25.EWA4.bin", where "boot system flash c...

Hello!Today I installed the CNA, created a new community and started discovery. All the switches were discovered with OK status except 3 switches behind other 2 switches that were discovered with OK. Those 3 switches have got status "Connection faile...