I need help, i have a cisco as5400HPX carrying traffic. The cpu processes hits 85-98% upon loading it with traffic. I have attached a log. Any thoughts?? I dont think its an IOS bug cos ive changed that....
I need a TCL script that can do this: Caller calls the platform. Cisco collects CLID. Cisco sends CLID to Radius which then Authenticates… IVR prompt tells caller to enter destination number… Cisco sends destination number to Radius for Authorization...
Hi all,i have an as5350 carrying voice traffic normally, but quite often, the E1s carrying traffic go down and come back itself again. The ios in it is a c5350-is-mz.123-6c.bin. On going through the log history, i got the following me...
Firstly,how many users do you have in each site?? that would determine what your design/topology would look like. Since you want this solution over the internet, i recommend you use DMVPN. This site below should help.http://www.cisco.com/en/US/docs/...
ran some debugs when traffic was low, but switched it off immediately. I have another box, an AS5400XM running smoothly (cpu 750Mhz) while the AS5400HPX which i'm having problems with run on a 390Mhz processor. Could capacity be an issue here...
