Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,Title lays my situation. I'm not sure about what I must do as this is my first migration. This post is a summary of what I think I know and plan to do, I'd like for users with more experience to just nudge me as to whether this is a ga...
Hello, I am setting up a 1:1 High Availability with 2 wlc 2504.I need to input primary and backup controller ip address and name at each AP.Unfortunately we have a lot of AP and more AP will come soon; doing this manually will take some times.I wonde...
Hi everyone, We have a Cisco wlc 5508 (with 50 LAP) running perfectly until yesterday when the wlc suddently stopped working completly.When we reboot the wlc, only ps1/ps2 led are on (alm led is off).We tried to reset the wlc but the wlc is unreachab...
I have configured a VTP (vlan trunk protocol) with Cluster Manager for managing VLAN. Unable to active ISL or 802.1Q trunk on the GigaBit Stack ports with Cluster Manager ou CLI.
"AP-specific settings of the HA takes presedence over the globally-specific HA settings"I tried to only configure the global setting then I ran:show capwap client ha And my primaryBackupWlcName/Ip are here so I guess I don't need to configure each HA...
I found the global configuration and have already put the ip/name of the secondary wlc.But I am not sure if it's enough because in this tutorial (Step 2/3) he configured the global configuration and the High Availability tab on each AP.https://rsccie...
