Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Is there anyway to create redundant inerfaces on a single router? Essentially, what I am trying to do is to imitate HSRP but on a single router.Whenever you try to add a second interface that exists within the same network as an existing routed in...
Hi,I am trying to selectively redistribute static routes into EIGRP. I have tried many different ways of doing it, but nothing seems to work. I thought it may have been an IOS bug (config changes not taking effect until next reboot), so I even reboot...
I have a router sitting at a third party's premises, connected back into our network via a Private IP offering (layer 3 meshed network provided by telco using virtual routers to provide a private network over their shared infrastructure). The telco w...
Hi,If you want to connect two switches together using two FastEthernet ports on each switch, what is the difference between using two straight trunks and using the two trunks to form an FastEtherChannel?When I configure the two ports on each switch a...
Hi,I have a WIC-1ADSL-DG card that I am trying to install on a 1751. The router detects that there is a WIC installed, but can not recognize what it is. The router is currently running 12.3(13) (c1700-k9o3sy7-mz.123-13.bin).I know that the Slot is wo...
Hi,I may have not made it clear - I am not trying to backup a WAN interface.I am trying to set up redundant Ethernet interafaces on the same router.Thanks
Hi Roger,I have successfully got this to work even with the summary route on. As one of the later posts points out, the summary route will only affect the routes that *can* be summarised - not the others.Thanks for your input though.
OK, it works ... seems likely that it was probably working all along and that it was only my naivitee in thinking that I should be able to see the routes being redistributed by looking at the local route table that was the problem. Thanks for all you...
Hi Marcel,Thanks for pointing that out ... I was confusing myeself it seems (by looking at the local routing table). I looked on the EIGRP neighbour and it appears that I am redistributing the route (see below).I have no idea why the second route is ...
Hi, Thanks for the reply.I read somewhere that if the static route was being redistributed by EIGRP that it would have a D or an EX next to it. However, the routes that are listed above are on the router that I am trying to redistribute *from*. So, i...
