Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiAnyone know what is the TCP time-wait of the Cisco ACE module. Below is the defination of the time-wait state in TCPThe client waits for a period of time equal to double the maximum segment life (MSL) time. This gives enough time to ensure the ACK ...
Hi allI notice that BGP default-originate do nit pass thru filter list etc and thus cannot be filtered.What about default-information originate, anyone know if this can be filtered or is it like bgp , it cannot be filtered? Hope someone know the ques...
Hi allI am new to ACE module in Cisco 6509. May i know how can i configure the ACE to access TFTP on my laptop. I have no problem accessing TFTP from the sup720 module.Please advice how to config the ACE to access the TFTP in my laptop. Thanks
Hi, Currently I have a 6509 switch on the 3BXL sup720 card. I wish to replace the 3BXL to the 3CXL sup720 card.Can I copy the existing config on the 3BXL to a CF card and copy the config to the new 3CXL card? Will there be any issue?Hope someone can ...
Hi I would like to know if it is ok to have configure more than 1 eigrp as on a single interface in a same router. Example would be as belowrouter eigrp 10network 10.10.10.2 0.0.0.0router eigrp 20network 10.10.10.2 0.0.0.0Will there be any issue for ...
Hi GillesThanks for the reply. I am quite new to ACE. I am wandering will port randomaization have effect on the ACE if I have a heavily loaded server that is load balance by the ACE. Hope I make some sense. Please correct me if i am wrong. Thanks in...
thanks for all the reply. Actually I got this from a lab. The lab is preconfigured to have eigrp as 1 on all the interface but thee a task to call me to configure another eigrp AS on the same interface. I am able to do that without any issue.Question...
Hi SteveThanks for the quick reply. Can I say that when i trace from A --> B, i get a sequence of 5 hops for example, than i trace from B --> A, it would be also the same 5 hops but reverse in sequence if asymmetric routing is not present? Thanks in...
Hi I agree with you that it is used to filter route. I have an example:If I had 3 router connected via frame relay in a hub and spoke design and R1 is the hub. R1 is connected with a sub-interface. If i want to advertise only a default route out R1 s...
