Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I have a Cisco 9300 in my network. I log all ACLs on this device, even "permit ip any any log".I am currently using more than 20 ACLs on this device and each ACL currently has over 900 entries with "log" at the end and "permit ip any a...
Hello everyone,i have a conflict. Despite the use of IPSec Tunnel in Crypto Map mode, the overhead is not calculated.The IP MTU value for us is 1500.I execute the command:"ping -f -l 1472 10.1.240.155"that is, I have 28 bytes as overhead.20 bytes "ne...
Hi everyone,I have a question, I would like to know whether there is a special feature so that you can create a nex-hop for a MAC address?For example :mac access-list xpermit mac xxxx.yyyy.zzzzroute map ymatch mac-access-list xset nex-hup a.b.c Tanks
Hello my friends!I created 1 ether channel between 4503E and 2960 TTL on 2 ports.Ether channel ist up but can not load balancing on 2 port. all traffics pass 1 port. The real bw monitor attached.where is my problem?
I checked the link so I asked the question.IP MTU 1500 bytesNew IPv4 header for IPsec 20 bytesESP header 8 bytesESP IV 16 bytesOriginal IPv4 header 20 bytesOriginal IPv4 Paylod X byteESP trailer 36 bytes20 + 8 + 16 + 20 + 36 = 100 byte overheadThat m...
thanks Rupik and thanks brselze!Problem resolved.So the load balance base on total traffic on all source and destination, not from 1 source and 1 destination.i tested with 2 source (last bit on sources is different after xor) on 1 destination. and ha...
i wrote show etherchannel in the top.4503-core-switch#show interfaces gigabitEthernet 2/47GigabitEthernet2/47 is up, line protocol is up (connected)Hardware is Gigabit Ethernet Port, address is 0011.21e1.9cce (bia 0011.21e1.9cce)MTU 1500 bytes, BW 10...
