Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I installed my WLC 2500 Serie ( 2504 ) on my network.I have an dhcp on my ASA 5500.It's working for my Wired link clients from my switch 2960.My AP have DHCP IPbut i don't now where i must go on my WLC to configure DHCP for my computer clients...
HelloHere is my problem, I have a small Cisco lab at home, and I wish I could set up, an ASA 5500 + 1 switch 2690 + a wifi controller WLC 2500 SERIE 2504.Here are all the details of my configuration:On my ASA, my Inside is on vlan 1I want to use only...
Hello,
My name is SebastienMy english is not perfect, i'm not natif of this language so i going to do my best.
I received my Cisco ASA 5505.
My knowledges in network Cisco and in general is very low so i have lot of questions, but for this time b...
Thank you very much.I tried last night after work, and it's work !!! Next step this weekend, try differents VLAN with mode trunk after, next step ! Best regards, Sébastien.
Ok, it's not clear ...
So i decided to do a new configure
I have internet ! it's work but, it's impossible to connect to ASDM
what do you think about that ?
ciscoasa(config)# configure factory-default 192.168.2.5 255.255.255.0Based on the insi...
When i write : show running-config i have :
Hardware: ASA5505, 1024 MB RAM, CPU Geode 500 MHz
ASA Version 9.1(7)13
my luncher is : v1.8(0)
when i write : show version i have :
Cisco Adaptive Security Appliance Software Version 9.1(7)13Device...
