Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I am just looking at putting a public cert on our Guest Portal provided by ISE. We have a pretty standard setup of a Primary & Secondary PAN as well as PSN and are using WLC Anchor/Foreign controllers. Our Guest users currently get the certif...
Hi All, I have just been looking into redundancy VPN's between ASA & IOS which has been successful with the exception of being able to get the floating static route to work correctly. Set up is ASA at head end with a single IP/ISP but at the far end ...
Evening All, I am looking to move away from IKEv1 route based site to site VPN's over to IKEv2. The current setup would be a HA pair of ASA's at the HQ RO2 internet and at the remote sites we would have dual ISP's going to a single IOS router, I am...
Afternoon All, I am hoping for a bit of help setting up a route based IKEv2 VPN between an ASA & IOS router. I have setup route based IKEv1 VPN's between ASA's & IOS routers with no problem but am really struggling doing the same with IKEv2. The ASA...
I was looking to do the exact same thing, as we have multiple sites that we currently route back over an MPLS network and out via an ASA site-to-site VPN from our DC to a 3rd party monitoring provider, the WAN IP's can float between DC's for resilien...
Hi MHM, Here is the tunnel configurations with the public ip address of the ASA being replaced with 8.8.8.8 interface Tunnel1ip address 15.0.0.2 255.255.255.252ip tcp adjust-mss 1380tunnel source Dialer1tunnel mode ipsec ipv4tunnel destination 8.8.8....
Rob my friend you are a genius That's done the trick, need to find some documentation so I can get a better understanding as to what disabling config-exchange request means but am very happy as none of the guides I have seen have mentioned this. Th...
Hi Rob, The IKEv1 setup is exactly as you described above. When I use ikev2 and create another ikev2 profile for the second ISP it seems to break the first? If I apply the backup ipsec profile to either tunnel interface the tunnel coomes up, however...
