Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I configured Microsoft vpn on a Win2k Server. I can hit the vpn when I'm inside the lan, but if I try to connect to it from outside I get the following error: 721. I hit the vpn server, but during authorization I get the error. I telnet t...
Hi everyone,I was wondering is there any way I can disable the ports kaaza uses, or is it a lost cause. I've checked the ports and it seems to use port 80, so if any one has found any way of disabling kaaza.thanks,aztemotheraztecmother@yahoo.com
Hi,I'm configuring cisco pix 520 to work with vpn client 3000. My question is when you specify the ip local pool address, must they be in the same subnet as the inside network?example:ip address outside 192.168.0.1 255.255.255.0ip address inside 192....
Hi Everyone, have a question, I have 3 different subnets from my isp. What I need to know is if the pix can handle the 3 different subnets or do I need a pix for each subnet. I want to disable nat, and have the machines using external address, with ...
hi madube vtl,it depends, if the microftp vpn client is useing the default gateway of the vpn connection then No, to turn this optoin off do the following, click on microsoft pptp client and go to propierties --> go to the networking tab --> hightlig...
Hi Lee,you should be able to use the backup interface command to set the microwave interface into standby mode. When the t1 fails it simply kicks in the microwave interface. example:interface s0/0 (using s0/0 as T1 example)ip addresss ####.####.##...
