Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to better understand the different loopback commands on the controller of VWIC cards. I am troubleshooting line code violations on a T1 data circuit(with no slips) and worked with a CO tech to do initial troubleshooting.They used their T...
I have a production VoIP network with a 100mb Ethernet WAN link(EoS) between a major site and a datacenter where CallManger and all servers are located. I installed a point to point T1 to carry voice traffic to the datacenter in the event the primary...
I am in the process of upgrading a 3825 from SP Services to Advanced IP Services.Currently running: 123-11.T5.binIf I understand correctly, the T series are for new features while the mainline incorporates new features from the previous T series and ...
Please shed light on my confusion.I am confused about network x.x.x.x. Does it include networks in eigrp routing tables, specify which interfaces to look for neighbors on, or BOTH?I have a small network with all serial interfaces on 192.x.x.x. Each r...
I have encountered the same exact problem. This is the command I used under the ATM interface. The default limits throughput to around 2.5mb.clock rate aal5 8000000
Here is my config:interface ATM0/1/0 description Connection to ADSL 6.0/768k bandwidth inherit no ip address no atm ilmi-keepalive bundle-enable dsl operating-mode auto clock rate aal5 8000000 no clns route-cache bridge-group 1 hold-queue 224 in pvc...
