About gballas01

gballas01 · 06-23-2016

Hello, So I'm figuring another Cisco 1921 Router (and have done a couple of these before) and have put together my "test" config (see below), based on my other working configurations and notes. Now when connected to the Router (via Teraterm), I can ...

gballas01 · 05-23-2015

Hi, Hoping to get a little assistance with this. Have found a few examples about the net, but all seem a bit different...They say picture worth a thousand words (even if a bad one, my apologies), but here goes: ...so here's briefly what I'm trying t...

gballas01 · 04-06-2015

Hi, Have a new project working on with Comcast EDI Fiber setup (w/ siena sw)The information from Comcast is as follows:(WAN Block)Link Ip: xx.yyy.186.248/30 GW: xx.yyy.186.249Layer 3 IP xx.yyy.186.250 (router is set here)Subnet Mask 255.255.2...

gballas01 · 06-27-2016

I was thinking more about this afterwards, and yes that makes perfect sense now. When I had first setup my other units (last year) I had the NAT calls in there to make things work (on the bench). But once I moved into production at client site, they ...

gballas01 · 06-24-2016

Success! Great Thank You. That did the trick, but while were on the topic..... About an year ago I had a similar problem (pretty sure), with basic same setup (router etc) for another installation (but was still setup and tested on my bench) ....and b...

gballas01 · 05-27-2015

Hi Andy,Getter closer now ..perhaps you can help me resolve my final (I hope) issue...I've included diagram and latest Config of where I'm at and also the sh ip routes info.(1st I'm testing in my office on my network, which I've done many times befor...

gballas01 · 05-26-2015

Ok so I've done some testing here's my current config: switch-xsg300-10pv1.4.1.3 / R800_NIK_1_4_194_194CLI v1.0set system mode router.........removed some security stuff.......... voice vlan oui-table add 0001e3 Siemens_AG_phone________......removed ...

gballas01 · 05-26-2015

Hi Andy ..and thanks for your quick input...but ...No Have not solved this yet ....got pulled into another mess earlier today...back to here now.Many thanks for your suggestions thus far and I'm going to try them out shortly...just couple questions f...

Member Since	‎04-04-2015 03:10 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	17

User Statistics

User Activity

Problem Configuring Cisco 1921 Router - Can't reach external ip addresses, websites, etc

Help configuring SG300-10p using VLAN's and/or DHCP components??

Cisco 1912: need help with setup to make "inside" static (public) IPs accessable externally

I was thinking more about

Success! Great Thank You.

Hi Andy,Getter closer now .

Ok so I've done some testing

No Have not solved this yet .