Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a problem with a template, when I want to deploy it, I can't see any equipment in the devices tab... Here are some captures to explain : I have other templates and no problem with them... I can't understand why... I use Prime Infrastructu...
Hi, I have a strange problem with one of my 2960x switch. The timestamp display a "." at the beggining of the line, for example : .Aug 28 16:00:30.951 CEST: %SEC_LOGIN-5-LOGIN_SUCCESS: And a correct one : Aug 28 15:51:18.428 CEST: %SEC_LOGIN-5-LOGIN_...
hi guys,I'm depressed, I can't get a working tunnel... I've tested everything I can, read docs, posts, etc... but it doesn't work.I need to extend my Vlan105 from the HQ to a remote site. Here is my setup : PC [Fa] <---> [Gi] Cisco 2960-X [Gi24] <---...
I add a new test stack without any config to check this problem but I can't deploy the template either...When I create a new template, the list is still empty
Yup it works... SP for remote site : VLAN0105 Spanning tree enabled protocol rstp Root ID Priority 24681 Address 001e.f70d.f080 Cost 12 Port 28 (GigabitEthernet0/4) Hello Time ...
