Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,I follow the cisco documents to check interface utilization in PI. (Operation >>Monitoring Dahsboards>>Performance>>network interface)But I can't see anything in it. Does everyone come cross this issue? (or any others config to be need to ...
Hi Expert,My office has a Cisco 2911 ISR router, we installed a 3560 service module 16P on it.But I use command "sh ip int bri" in 2911 router when we finished installation.The result shows that the interface Gi 1/1 doesn't work, I have try to re-ins...
Hi Expert,We already have a stack switch (with two 2960s switch), we want to add new 2960s to it.I search some document in cisco.com, it's said we only need to disconnect old stack cable and then re-connect the new stack cable at all.And then the new...
Hello Expert, I just running Cisco ACS 5.2 in test system. I removed all default service selection rules, and then I create a new rule by myself. But I try to log on router, the ACS display that the action is matched with the Rule-2. I have no idea w...
Hi Krishnendu,I understand what you mean, I have done this work for assign Gi 1/0 an IP address, and then using command "service-module gi 1/0 session" to enter the service-module to configure it at all.But I just want to know what is the Gi1/1 inter...
Great, thank very much, Leo !!I have another question is:I don't need to do anything config on the new switch, I just need to upgrade the new switch's IOS version as the existing stack.After doing above task, I connect all stack cable and power cord ...
