Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a Cisco 831 DSL router pulled from working environment. I've tried a number of CLI entries to get the router to simply connect to the Internet with no success. At one point, I could ping Internet provider gateway and DNS server. I know more t...
I am able to remote telnet to a 804 ISDN router provided I telnet from a workstation that is also in the same ISP domain as the router. I'm using NoIP DSN for translating the 192.x.x.x IP address of the router to a host name. When outside my ISP d...
Over the last few days, ISDN connection would disconnect with just a few seconds of inactivity even though disconnect is set at 300 seconds. Often, clear int bri0 was required to reconnect. Follosing is part of message with the clear command:PANIC!...
Yes. Attached is a Tracert that indicates my ISP is dropping my Telnet request as if I have the ability blocked at my router. Again, I can Telnet from behind the router, and if I am in the Fidnet domain (my ISP as indicated by Tracert) I can Telnet ...
No ACL on VTY lines. Here is the access-lists and VTY line capture portion of my running-config (couple of redundant entries, I know):access-list 1 permit 192.168.0.0 0.0.0.255access-list 100 deny ip any host 255.255.255.255access-list 100 deny ...
Your suggestion to use the e0 "in" resolved the problem. A number of us administrators would save some time if we just activated the log or the "capture text" every time we're configuring, instead of assuming, "It's going to be easy-no log necessary...
Thanks mate,I thought this would be so easy that I didn't record what lists and interface apps weren't working, so I think I became disorganized and never did use:access-list 2 deny xxx.xxx.xxx.xxxaccess-list 2 permit anyint e0ip access-group 2 inKin...
I couldn't get any q921 output last time. But I'll probably be on site when it occurs sometime in the next two weeks, and I'll try again. This router is running 12.1 version software. Rick
