Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Techs,Today I ran into some abnormal issue while using select VRF feature. I have pointed a static route with 2 different VRF's & redistributed the static routes in BGP Address-Family, when I leak the route from different VRF (import & export ...
Hello Guys,I am working on below topology and I am facing issues of route refresh in ospf routing tableon both ABR's due to which connectivity to Internet is going down and up.I am seeking your help to know the issue and help in troubleshooting the i...
I want to configure rate-limit command under SVI's created in 4500X, but when I try to run this command it doesn't support this.Can anyone help me and letting me know how can I configure the rate-limit command under SVI'sMany Many Thanks for help.
%SYSTEM_CONTROLLER-SP-3-ERROR: Error condition detected: TM_DATA_PARITY_ERROR Feb 2 10:57:09.602 EST: %SYSTEM_CONTROLLER-SP-3-EXCESSIVE_RESET: System Controller is getting reset so frequently Cisco Internetwork Operating System Software IOS (tm) s222...
Hello Peter, Today I have seen very abnormal behaviour in 4500X. I have created SVI and advertised in OSPF. Everything is working fine but when I see the traffic counter , I am surprised to see that on INPUT there is a traffic but on OUTPUT there is...
Good Morning Rolf,As per the logs on 6500 (ABR's) I don't see any logs of interface going down but yes its shows OSPF going down and loading for AREA 2 & AREA 4 Neighbors. Connectivity is on fiber (SM Mode Fiber) and for the links I dont see any lin...
Hi Rolf, 4500X are also ospf neigbor back to back ove vlan 20 (192.168.2.8/30) & neighborship between them is stable up since 2 days. I haven't configure the router-d command till yet but will do the same, meanwhile I am just wandering what could be ...
Thanks Daniel, how shall I configure the below command with shape average command in 4500X ? I have created the configs below , can you please confirm if its correct ?Old Wayrate-limit input 4096000 768000 1536000 conform-action transmit exceed-actio...
