Sir,Following is the output of my E3 controller.What is the meaning of E3 9/1/0 is up.How to avoid 11 P-bit Err Secs, 11 P-bit Severely Err Secs, 11 Severely Err Framing Secs, 71 Unavailable Secs, 0 Line Errored Secs, 11 C-bit Errored Sec...
Dear Sir,normally cisco 7609 and cisco 3725 will take how much current.show power output of cisco 7609 issystem power redundancy mode = redundantsystem power total = 3795.12 Watts (90.36 Amps @ 42V)system power used = 1713.18 Watts (40.79 Am...
sir, why ICMP Port Unreachable from gateway 10.40.20.154 for udp from testserver (10.40.2013) to 10.20.250.16 port 33440 error message is coming.testserver # ping -s 10.20.250.16PING 10.20.250.16: 56 data bytes64 bytes from 10.20.250.16: icmp_seq=0. ...
Sir,I have attached the output of sun server.what is the reason forICMP Port Unreachable from gateway 10.40.20.154 for udp from testserver (10.40.20.13) to 10.20.250.16 port 33440.whetehr it is server problem or switch problem.testserver # ping -s 10...
Sir,Actually switch is having two vlans.vlan 1-10.20.250.3 and vlan 2 is 10.40.20.154I can able to ping vlan ip 2 (10.40.20.154) without any loss from server.While pinging vlan ip 1(10.20.250.3) then only this problem is coming.Regards,Senthil
Sir,Thanks for your reply.i have removed trunking on 4507 switch.But still same problem exists.Ping output is as below.testserver# ping -s 10.20.250.3PING 10.20.250.3: 56 data bytes64 bytes from 10.20.250.3: icmp_seq=0. time=0. ms64 bytes from 10.20....
Sir,i have checked that link.As per that link i checked server.In server eeprom mac-address is true sir,Whether the problem is server or switchRegards,Senthil
Sir,It is working multilink.sometimes only (for two days one time like that)this type of status is happening.That is showing up both sides but not pinging.After issuing shutdown and no shutdown commands at interface multilink it becomes ok.what mi...
