Hello!
We are looking for an FXO adaptor to terminate a single POTS line at a remote site. We are not looking for an FXO card sitting inside an ISR serving as a gateway, but rather a stand-alone adaptor that will integrate with CUCM 10.5. Hoping ...
Hello!
We have a CUCM 10.5 Cluster consisting of PUB and 3 SUBS.
PUB and SUB 1 are at site A, SUB 2 at site B, SUB 3 at site C. We have a CM Group (CMG3) with SUB 3, SUB 1, SUB 2 - in that order. The Device Pool that is assigned to all the devi...
Hello everyone,
Need some assistance. We have a remote office hosted off CUCM 11.5. The remote office is serviced by and ISR MGCP gateway configured with SRST to support both SCCP and SIP phones. Everything is working fine when SRST kicks in. B...
Thank you Jaime!
I found a thread where someone integrated it with CUCM 8.5, but it was not clear if they used it for FXS or FXO since it supports both. There was no mention of dial peers.
I'm looking for an economic way to integrate a POTS/FXO...
Just wanted to drop in an update in case someone encounters similar behavior.
As eluded to in the original post, the issue impacting Site C's call processing was apparently caused by WAN link saturation at Site A, where the PUB is deployed. Althou...
Update: In case it is helpful for anyone else. We solved the issue by building 2 dial peers. The first facilitates Inbound PSTN calls via the PRI. The second facilitates Outbound PSTN calls via our PRI. We then applied the clid network-number 21...