Hi All,TopologyERSPAN source Site A----(SP Network)--------Site B (Erspan destination- ( Nexus device) ) I know we can apply ACL on ERSPAN source session only. But my requitement is to configure ACL at ERSPAN destination session end. Is there any w...
Hi All,TopologyERSPAN source Site A----(SP Network)--------Site B (Erspan destination- ( Nexus device) ) I know we can apply ACL on ERSPAN source session only. But my requitement is to configure ACL at ERSPAN destination session end. Is there any w...
Hi All, Switch/router------------Accessport- --eth1/23(vlan 100)-Nexus 9336 --access port vlan 200------eth1/30&1/31-- Switch/router is sending the copy of their wan traffic towards Nexus on port 1/23.I want to capture all this traffic and send or re...
Hi experts,Need help .CustomerMGW-----SW-(trunk)--------(2 Sub-interface)-PE1-----------------PE2MGW is telecom device.PE1 and PE2 is directly connected with gig port.MGW is customer.Form MGW device to connection is terminating on SW and they assigne...
Hi,IN MPBGP protocol, where i will apply routing policy to apply as- path prepand so that Route would be secondary to neighbor.IGP-OSPF and BGP over MPLS is running.on Which address-familiy nbr,should i apply, is it in VPNV4 or IPV4 or IPV4 V...
Hi, Change IP 10.10.10.1 to 172.25.200.10 in your ERSPAN source and destination session. Both session must have same IP in ERSPAN when you are using it as local span.
Hi @Sergiu.Daniluk ,Thanks. So basically you received a spanned traffic and you want to span it further to probably some monitoring or IPS/IDS devices, right? ---->Yes I would say that a simple local span should work, And the second problem is that y...
Hi Rock,you are getting the error because ingress TCAM region do not have space(size) to allocate to VACL."ERROR: Aggregate TCAM region configuration exceeded the available Ingress TCAM space. "You have to decrease the size of other ingress TCAM to...
Hi.Mahiesh,the dropping issue is resolved by making MTU size=1500 on both side.In normal ping , there is nodrops observe ie ping vrf name x.x.x.xBut still i am getting drop while pinging loopback of PE2 using ping mpls PE2_loopback_ip cmd.Herer --PE...
Hi Mahiesh,Could MTU Mismatch be the issue of dropping?On My side(PE1) MPLS MTU is 1500 B and Other side (PE2) ,MPLS MTU is 1488 B.On PE1 ,IP MTU is 1500,so what will be the recommended MPLS MTU?( we are using MPLS L3VPN .)please suggest.Thanks and ...