Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Yeah I know this has been covered already. I have the following issue. I have a two segments on the firewall, behind these 2 segments I have two L3 devices. VL622 is the higher security interface at 80 while VL621 is lower at 70.I have a static:stati...
I am looking at upgrading a 515E to 7.2(X) release but I am wondering about the memory requirements. The PIX in question has 64MB Ram/16MB Flash, UR and FO licensing. I keep seeing in the memory requirements that it needs to be a minimum of 128MB Ram...
I currently have PIX 515 setup running ver 6.3(5) in an active/standby configuration. I was wondering if it is possible to upgrade these to 7.0 and run them in an active/active configuration.
I have an issue where I need to bring a network into our network but because of that fact I can't route 172.x.x.x addresses through our provider (British Telecom Private Network)I need to figure out a way to nat a zone to another. The group is coming...
I know alot of these configs have been covered here and have read a few today. Here is my dilemna. We have a VPN concentrator in our GO in Florida. We are setting up a remote contract site in another state. The customer is allowing us to place our PI...
Yeah I know. By design but it kind kills a troubleshooting tool for firewall guys who can't get their routing and switching peers invovlved and are troubleshooting remotely on an issue with an end customer who isn't alway IP savvy. Would be nice if ...
Funny thing happened on the way to the ping desitination, which by the way is a mainframe that happens to be doing RIP back to the L3 devices between the firewalls and mainframe. We suspect that the mainframe sees a better route in its own table. We ...
I figured that would be the case. Makes me miss working on routers sometimes.As far as the issue I am having goes I'll put your recommendations to a test. Thanks for responding.
Arul,Thanks for the reply. Currently the customer is not in the position to upgrade the RAM or replace the firewall. The logic behind the upgrade is that they have hit the limit on interfaces 6.3(5) will support(VLAN/Physical)and the only workaround ...
