Hi ,I am trying to setup an ACL capture on Nexus 7K as we need to have more than 2 span sessions.The capture is working however the wireshark traces only show the L2 information and not the L3 header.Has anybody come across this issue and has any ide...
Hello All,We are planning to convert our 6509 chasis' into a VSS.Each chasis house an FWSM.The chasis are running the following IOS- Release 12.2(33)SXH8b and FWSM are at 3.2(Application software)We understand that the FWSM need to be upgraded but ar...
I was trying to find a document that explained how and where different types of OSPF stub areas can be used(like spoke locations, partners etc).If anyone has such an explaination, please share.
Hello,Has anyone implemented and is it possible to setup Cisco Webex using Multicast.We have a Webex account and about 600 of our remote locations participate into a Webex session every Thursday. These sites conenct through a Hub Datacenter and consu...
Hi Varun,I've checked the releaase notes for 4.0 & 4.1 as well however none of them mention the IOS version that I am running.So I am not sure if this is compatible with the FWSM software.Regards,
Thank You Craig....I also want to know about the NSSA and Totally NSSA types.As I understand, NSSA areas dont have a default route, so the only reason is redistributed routes.Can you advise where we would use these areas(NSSA and totally NSSA(Cisco ...
Thank you all for the responses.I am unsure what satellite applications mean.I noticed the tunnel MTU as well and I am not sure why that is so, however the tunnel transport MTU shows 1472.EIGRP bandwidth is set to 100% by using "ip bandwidth-percent...