Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, So i recently got a Cisco Secure Firewall ISA3000 and i was trying to set it up, however, i noticed that my interface commands are different. mobile(config-if)# int Gi1/1mobile(config-if)# ip address 10.10.1.37 255.255.255.0^ERROR: % Invalid i...
I'm currently using latest version of ASDM, but have the original ASDM Launcher version, what is the newest launcher version and should i be updating that as well when i do my patches to ASDM?
I have two swithches both IE-3000-8TC i'm trying to set a trunk for them. Both these interfaces are duplex full, speed 100 and type 100BaseFX Fiber connections. switch a: interface 2/8switchport mode trunkduplex fullendswitch b: int Fa2/7switchport m...
Hello,been getting a message that says NATIVE VLAN MISMATCH discovered on SWITCH B GI1/0/46 (207). , with Switch A Gi0/3 (1). so i see switch A has a trunk on port 3 allowing 1-207,209-769,772-4094and switch B has vlan 207 on port 46. If vlan 2
We found a fault in one of the fiber patch cables at one side. We swapped patch cable and it let me connect both ends its up now thank you for your help, greatly appreciate it.
yes, so i was using the sfp expansion module for the IE-3000-8tc. . so they were using the exact same sfp and same muiltimode fiber patch cable at both ends. I ended up placing a new sfp at both ends, GLC-LG-SMD-TRI taht was good for 10km. my distanc...
Yes, we swapped them around to see if we would get a connection and still nothing. we are running from one location to jump box then using patch cable to second location.
