Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone tell me what is considered best practice when traffic shaping is required due to a fast ethernet carrier handoff, shaped to 20mb?traffic-shape rate 20000000 200000 0 1000I currently have voice calls traversing over the 20mb link that exper...
I'm having trouble with a 6509 reloading after installing 48 port 10/100 blade.The switch is writing a crashinfo file, but I'm unable to read. I've tried txt, rtf etc.... What am I missing here?I'll rate any helpful posts.thanks
Hi all,Over the past two weeks our network has been experiencing sluggish intermittent problems with a Frame over ATM circuit. Nothing has been changed from our side, and the fault only occurs every day or to during peak business hours. I've checked,...
Hi all,Over the weekend I tried upgrading our 6509's IOS. I followed what I thought were the correct procedures from the cisco doco but had an error.When reloading this error occurred:Autoboot executing command: "boot bootflash:c6sup22-jk2sv-mz.121-2...
Hi, I seem to have a recurring fault with DFM when opening Device selector. This time I temporarily disabled DCR syncing from the selector page, rediscovered two troublesome devices, then tried to open device selector page again to receive:Problem wi...
Hi, thanks both for the response. I should have made myself clearer in the original post. My config currently shapes traffic to 20mb on the physical fa0/0 interface. This is via the traffic-shape command.Also applied to the same interface is a servic...
I've tried opening with wordpad. The file is actually in hex, rather than ASCII. Both methods for IOS dont work with CatOS, the more command and show stack aren't supported.Thanks for the suggestions anyway.
