Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Thanks in advance for any suggestions.I'm using RME 2.2 IDU 12 and am trying to update the archive (new installation) to compare configurations. When I select the devices to update I receive "Partially Failed (Note VLAN.dat fetch failed)I've verified...
I'm new to the VMS arena and recently took over the responsibility of managing the product.I'm running out of drive space on the VMS server. Which would be the more advisable solution?Install new larger drives and reinstall the product? What should I...
Where does the VMS server pull the username (TACACS+) or Enable password from to push MOTD (test) to a device (3524 switch)? I've tried creating a new job in NetConfig and receive;Could not establish telnet session to device: :PGM_NM=configuration ar...
We've recently purchased the new VMS, yet we still have the older version of the CiscoWorks 2000. Is it possible to utilize some or all of the components from the previous product on the new VMS server? (ie; new VMS has vpn security, nids, firewall a...
Jul 18 22:00:39: DHCPD: dhcpd_age_bindings could not lock semaphore.I've researched and can't find anything on this error message from a 2651.Can anyone shed some light on what it means? I have several systems on the remote end that loose their dhcp ...
It all depends on your infrastructure. I have a mixture of Cabletron, Cisco and Ascom Timeplex. In addition to CW2000 and VMS I also use;Concord E-HealthNetScout (w/FE - GE probes)SPEL (Spectrum Analyzer)Concord is useful when showing up/down status ...
What version of IOS are you running? Is the WIC a version 1 or version 2? We've found that an older 2650/2651 router will not run with the version 2 WIC. The only router that we've found that will work with a version 2 WIC is the 2650MX/2651XM model....
I had a similar problem (48mb) flash and had to;Boot the router and delete all imagesSqueeze the images from the flash/bootflashFormat the Flash Card and copy the bootflash / IOS to the cardCopy from the disk0: or disk1: to the Router and BootflashMo...
