Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a few new aeroscout RFID tags that I was told would work with Cisco LWAPP/Location. I don't see them connected but they are powered up. I was told you needed to buy software to configure the tags for advanced settings but they would also wor...
I have our new WiSM installed and setup. WE can access the WiSM with no issues. Latest code is running on the WiSM/AP's. An AP will connect and show up in the WiSM about after about 2-3 mins the ap will disconnect and go back into discovery mode. ...
I have been having some serious issues with my 1121G APs over the past few days. I recently upgraded to 12.3-7 and for unknown reasons the AP's are creating r12-*****.rcore files. These files will fill the AP's flash memory and render them useless,...
For rogue detection, I would like to be able to import all my switches on the network, we currently have over 400 with a mix of 3550's and 2950's. The way I see it you can only import switches on the network that have a wireless device hooked to it....
I'm running 5.0 code on 6 WiSM's with around 1200 access points. So far so good as far as reliability goes. WCS running 5.0 code has some quirks but nothing major so far.I suggest you keep all controllers at the same SW revision. As noted in anothe...
