Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team, I have tried to go through the following links but i am unable to join the pieces together.I have user with system level privilege. I have downloaded the xml schema however i cant understand how do i use them in my python script and make OCI...
for example:i have 5 sites: A,B,C,D, E andeach has local gateway: GA, GB, GC,GD, GE. if you have to route calls through local gateway for each site your configuration will look like this. Route pattern 1: 9.XXXXXXXXXX ----> Routelist1---> RouteGroup-...
if during the call you can run the each command thrice in an interval of 10-15 seconds.show call active voice briefshow voip rtp connectionsRegards,Adarsh Chauhan
Hi, You should have option ping enabled on cucm for the trunks as well as on the dial-peers.if one dial-peer fails it should route it through another dial-peer.if trunk between cucm and gateway fails depending on which layer it will mark the trunk do...
Hi, If a route pattern has route list which has standard local route group then Device pool comes into the picture. Regards,Adarsh ChauhanPlease mark helpful or correct.
Does it work without sip-profiles 100can you remove sip-profile 100 from global configuration and isolate if it works without that.Regards,Adarsh ChauhanPlease mark correct or helpful
