Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Pix 515 and the DMZ is very slow since upgrading the firmwaire from 6.3 to 7. The Pix only has 64mb, but we are having a 128mb sick delivered this week. Will this improve the upload speed to the FTP server? It was so much faster before t...
I have been trying to upgrade a few VPN clients from the 4.0.1 release to the latest which I think is 4.8 or 4.7. What is the best way to upgrade these uninstall and then reinstall the new one. I tried this on a couple of laptops and one it can't c...
I have a Cisco 837 router and I want to backup the config our TFTP server, what command do I need to use please? What I want to achieve is backup the configure, then change the configuration of the router so it doesn't work properly, then restore th...
Our Cisco 515 is running firmware 7 which apparently allows us to do QoS. We have VPN's comming in via the Pix and into a Cisco Concentrator 3015, how can I prioritise the VPN over users internet access?
This is what it says:vogate# show interfaceInterface Ethernet0 "outside", is up, line protocol is up Hardware is i82559, BW 100 Mbps Half-Duplex(Half-duplex), 10 Mbps(10 Mbps) MAC address 0005.8ac0.d520, MTU 1500 IP address *.*....
Hi all, I forgot to mention it was fine before the upgrade, the average memory usage before the upgrade was 26% now it is 65%. Sorry it is 7.1 just checked.
If the router is on the same IP range as the TFTP server I can do this, but if it's on a different IP range I can't, however I can ping the TFTP server from the router and there is no firewall inbetween.
