Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am using cisco content engine for caching which is in my central site. I am able to open the vedios from my central sites. But when i try from remote sites its not opening, is there any config required for pointing to the content engine at my ce...
HI,I am into R&sitching and want to step into PIX. I got the IOS of pix 500 series and when its boot its giving invalid activation key. Does the key differ for each feature set. From where can i obtain the key.
HI,I have few doubts with the FRTS. The below are my configuration;map-class frame-relay DLCI_935_Voice_New frame-relay mincir 960000 frame-relay traffic-rate 960000 960000 frame-relay adaptive-shaping becn service-policy output CBWFQ-VOICEWhat exact...
Hi,I am trying to redistribute RIP into OSPF and in my area 0 i can see the RIP routes as E2. But i cannot ping to the RIP domain from area 0 and vise versa. What can be cause of this?
Hi,I am using the IPSEC tunnel but enabled the IP mtu under tunnel. Is it a good practice to enable IP mtu under tunnel only. Also what exactly the "ip tcp adjust-mss" will do?Please explain.Thanks in advance.
Hi Mahmood,The subnet keyword is included in the redistribution, but still i am not able to reach the RIP domain even though the Route is avaliable in the OSPF domain.
Hi,I am using the IOS c2800nm-adventerprisek9-mz.124-19. The HWIC is connected on port1. Is there any way to enable the slot, as its saying port is disabled. Will the above IOS support this card.
