Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys , I need some assistance regarding CTC, we got one project in which the traffic is already flowing with two networks reflecting redundancy of DWDM. Now the issue is that on CTC, we can only see one network with all proper configurations. But ...
hi thanks for the information , in below case do i need PAK to enable throughput feature License Level: adventerpriseLicense Type: PermanentNext reload license Level: adventerpriseIndex 31 Feature: throughput_20g Period left: Not Activated ...
thanks for the information. my question is that we can accomplish the same result as below1. track 10 ip route 10.2.21.128 255.255.255.0 reachability3. standby 10 priority 2004. standby 10 track 10 decrement 60then what is the main r...
access port , initially it was 12 MAC addresses then after that PC switched off it decreases to this valueinterface GigabitEthernet2/0/33 switchport access vlan 800 switchport mode access switchport voice vlan 316 no logging event link-status authent...
