Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We just stood up a Webex Meeting Server onsite, and we've had a couple users that we have had a heck of a time with. Just users that had previously had the Webex Assistant homed to the "old" webex.com service. Switching it to the new site appears to ...
I am currently working on an 802.1x pilot. I have successfully deployed certificates for PCs and users and I'm able to assign VLAN etc in a reliable fashion. I would like to enable MAC Authentication Bypass on the voice VLAN for IP phones. The proble...
The headend is an ASA5510 running 7.2(2). I will post the config if requested, but here is the gist of it:I have a nat exempt ACL and a corresponding nat 0 statementI have an identical acl for the crypto mapI have sysopt connection permit-vpnI have a...
I have a 2821 running 12.4T. I am trying to use OER to utilize the directly connected 2xT1 and an ethernet connected cable modem/router. OER works wonderfully (except it doesn't seem to restart if an interface goes down) but one little wrinkle: The m...
Sorry if the answer is obvious and I've missed it-is OER supposed to restart after an external interface drops and comes back up? My scenario:Cisco2811 12.4(11)T2 IPADVSVSMaster and Border process on same routerExternal interface 1 = MFRExternal inte...
We ended up getting it working, but we didn't try anything new, it just finally allowed us to switch servers successfully with the assistant. We've had 5 or so people that were using the tool with the "old" service, and 2 of those have put up a reall...
Thanks for the reply! The NAT statement references the correct interface, but a good guess. Here is what I think is the salient part of the configuration:access-list alarms-no-nat extend permit ip host 192.168.0.14 192.168.10.0 255.255.255.0access-li...
ChrisWe're running the 6.1.1587 on the CSC-SSM-10 and 7.2(2) on the ASA 5510 with about 175 people behind it. We had the processor running at 100% all day with the last rev of CSC software (6.1.1569). The newer version appears to be a little more pro...
We have a CSC-SSM 10 in a 5510 that is configured just like your first example, and exhibits the same behaviour. I've loaded the latest SW on it with no improvement (despite the fact that the "caveats solved" section implies this is fixed.
I've checked that ACL (I'm logging on it) and seen *some* hists, but not nearly as many as there should be. It almost looks like it's matching traffic when that server initiates a connection out but not when it's replying to a connection started from...
