Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, all.Give me informations on access list for NAT.Cisco IOS Master Command List, Release 12.4 describes the ip nat inside destination command, the ip nat inside source command, and the ip nat outside source command use standerd IP access list for d...
Hi, all!I had used Internetworking Terms and Acronyms in old CCO site.But now we don't have any former tech documents link to the old site.We have reachability to it by search engine. But if I forget the word Internetworking Terms and Acronyms, I can...
Hi, all.I am an engineer in Japan. I have no chance to know what are the right pronunciations for follows in English. 1) 255.255.0.0 (two five five point two five five point zero point zero?)2) 192.168.100.50(a hundred and ninety two point a hundred ...
Hi, all!I can not find out the atm pvc command in IOS command references at CCO. But that command is shown at page 176 of 'IP Quality of Service' by Cisco Press.I want to know parameters of this command.Please give me a guide of this question.Thanks.
>But the document follws uses extended IP access list for dynamic NAT in Difference between One-to-One Mapping and Many-to-Many section.Hyperlinking slipped my mind.http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.sh...
Honestly speaking, I couldn't understand what you meant. But I see it now.User side ISDN interface cannot pass any signal to the opposite end of the line, if it also is User side ISDN interface. I shed tonight till morning so that the golden slumber ...
Thanks for your hint.Important infomations slipped my mind.I have some Cisco 2500 routers and Cisco 4500 routers with multiple BRI module.I want to let this 4500 relay at my home labo.Does learning ISDN deeply make this come true?Because Cisco's ISDN...
