Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Attached are the config of our two remote routers one behind the other.We two have WAN connection links (Radio and fibre) but the radio do not take over network traffic during the fiber link outage.The fiber link is directly connected on a routed i...
We have just acquired a set new LAP1142N but they cannot successfully register with existing 4402 WLCrunning .Other existing APs include 1130AG and 1240AG.Any idea what could cause thsuch problem
We are currently experiencing high utillization on our regional WAN connections.In this scenario, we used to track this situation using IP accounting on the WAN interfaces.We recently upgraded WAN routers to cisco WS-C6509-E Mutilayer switches.When w...
We are currently experiencing high utillization on our regional WAN connections.In this scenario, we used to track this situation using IP accounting on the WAN interfaces.We recently upgraded WAN routers to cisco WS-C6509-E Mutilayer switches.When w...
Problem traced to static route on Near end remote router.Therefore the router ignores ospf at the Near end remote but adheres to it at far remote.Since the Fiber link interface is connected through a media converter, the interfac will remain always u...
Many thanks for this info. My controller runs version 4.1 as can be seen on the output below.************************************************************************(NGPHCIAWC002) >show sysinfoManufacturer's Name.............................. Cisco S...
That's if i have realtime traffic transversing the link. At this point traffice hass been re-routed via another link, and i wish to see the rate at which the service provider DCEs is clocking my DTEs. That would tell me the Bandwidth for which there ...
The CSU/DSU in this case is embeded in 2 satellite modems, which connects the two ends of the link. Each modem terminates directly on the routers at both ends. The toplogy is a simple point to point connection, just like two radios facing eachother.I...
