Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I am trying to debug our setup that is having an issue. The goal is to have 2 remote AP connecting back to our main building using 5GHZ. The 3 AP's are autonomous 1572 EAC running 15.3. Apart from the IP address, both remote AP have the sam...
Hello all,I am trying to obtain signal quality and strength using snmp. I see that the OID are 1.3.6.1.4.1.9.9.273.1.3.1.1.3 and .4When I try to retrieve those values using snmpget, I get that these values don't exists. There has to be something else...
Hello Community !! We are looking to buy multiple 48 ports -10 Gb switches. One model proposed by our reseller is the nexus 93108TC-EX. Going through the documentation, I don't see anywhere that it support stacking. Am I missing something or it reall...
Hello all,While diagnosing another issue, I noticed that during boot up some logs showed up mentioning that Smart Licensing had been turned on. After reading about our current version, it said that Smart Licensing is the only way to go from now. The...
Hello all,I have 3 new switches that were stacked and working properly. They were numbered 1 - 3. I renumbered them to 3 - 5 as they will end up in an existing stack.After rebooting, the whole stack is stuck into a loop. I followed someone's comment ...
Hello rrudling.going back to the snmpwalk result starting from the top (no oid provided), it shows me the ifindex of 7 for the radio interface where the communication takes place.for other people trying to obtain those oid values, as rrudling mention...
Hello ammahend,thanks for your reply, I was not involved with the purchasing. On the other end, I was able to connect to the main site using a laptop so the antenna should be fine.I believe at this point that it may be an antenna alignment problem. I...
Hello rrudling.You do understand how SNMP works right? I am no expert but know enough to get by most of the time. Somehow in this case, when doing the snmpwalk on the device, I could not see anything related to that table. I did not know about doing ...
