Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings.I have a 2F-BLSR and I upgraded from TCCs to TCC2s. All went well until I went to remove my locks from the spans, but it just locks up the whole network in that I have to reset (physically or manually) the TCC cards to get back to CTC!I can...
I had an 'on site' consultant thought he was doing me a favor by removing and reinserting cards (DS1-14 and an E100T)in one of my chassis during a network problem. Nothing was wrong with the ONS at that time. One card got stuck in a persistent LD sta...
Has anyone ever connected two organization's 15454s together with either a subtend ring or PTP and NOT allowed one another access to each others CTC? We want to use our respective systems to transport another parties traffic, but despite organization...
c6509, Nam2, SW 7.4(3)Worked like a champ for weeks. One weekend, started sputtering with intermittent output to the web interface...then died. I can boot into the maintenance image,but I have no access. Do not know if it is id10t admin error with pa...
Okay, it worked for months, now it does not. We have two cat 6500s at the core being core/distro switches. The redundant cat lost its way on boot up one day so we had to massage the boot statements, but did not change the hybrid CatOS or the IOS for ...
Yes, the cards are in the right spots for the type of card if that is what you are asking. I did not know you could replace the slot per se.SLOT 1 went into 2 and SLOT 16 went to 15. Should be good. Even with the cards removed and green in their new ...
Thank you. I thought about that, but we are transporting ethernet circuits for this third party across our platforms. If we kill the DCC, can we still cut in circuits?
I finally got it. I had tried a boot loader image before...but it would just error out or just sit there. I tried it again with the xmodem terminal set at 38400 and it worked like a champ. Recovered the switch and life is good. Go figure. I used the ...
Bad news. It does not matter because I cannot get to the bootflash on the MSFC2. I tried bringing what I thought is a good CatOS for mod 15 over (c6msfc2-jsv-mz.121-19.e1.bin) on a PC Card-slot0: but that won't initialize and read the image-it won't ...
