Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is a working config for meetme conferencing that should get you up and running - Once the feature is enabled, to initiate a meet me conference, the first phone goes off hook and gets dial tone. The conference Initiator then presses the MEET ME b...
Log into the server as administrator and check the services - if CCM is installed there should be a series of Cisco services including CallManager. It should be configured as Automatic start. You should also be able to access the admin pages via star...
Set the bandwidth on netmeeting as LAN and this will allow you to select G711ulaw as the main codec under the advanced audio settings. It's likely you are using the Netmeeting default G723 codec and CallManager is having a problem with this - the 79X...
You can use a FXS port on the same chassis and point a POTS dial peer towards it, and have a outgoing POTS dial peer pointing to the BRI ports. The DSP should be dropped from the connection between the ports if the companding is the same, so you will...
