Hii have Cisco 9115 axi AP, when i plug in my switch POE, it doesn't turn on in my switch(like the port is down, but it doesn't), but in the side of my AP, i see alternate red and green ligth.See below the initial boot messages error
Hi Guys, I have Cisco ISR 4321 manage voip in my company. the issue is : When I want to call another IP phone in the building of my company(internal), the ring is ok, but when I want to call a local number or a mobile, it takes 50 seconds to have the...
Hello guys,I have 2 switch nexus 9000, i configure two interfaces like below :interface eth1/1switchportswitchport acess vlan 10no shinterface eth1/2switchportswitchport acess vlan 20no shNow i create and configure the vrf to the interface vlan10 & 2...
Hello guys,sorry to answer late, i enable both cdp and lldp in the switch, but it is still same. before i used C1000 switch, now i changed the witch with C9200L, but same issues
Thanks @Marvin Rhoads, after reading this log, i saw that the issues cames from the firepower user agent was enabled, i disabled this one, since it doesn't supported it by FMCAfter disabled it and check again, it works like a magic. Thanks guys.
I all checked, everything seems like good. I read all notes and know that i can't upgrade from 6.6.X to 6.7.X to datastore issues, but i would like go to 7.0.X or 7.1.X or even 7.2.X, but i have all times a Failure.