Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,The Credential Verification Report provides a way of checking if the credential used to access devices on the network are OK and that the switches and routers can be reached using this information.However we can only view a report which at most ti...
Hello,The "copy tftp flash" command on PIX will erase the existing IOS image in the flash and write the new image into the flash.What is the procedure if I wanted to save the existing IOS image before the upgrade?Is there a copy flash tftp or equival...
Hello,I have also run into the same (progress is stuck at 10%) problem. I believe in my case, it started after I installed the service patches 2 for DFM. I have uninstalled the application (DFM) and the patches and reinstalled DFM alone without any s...
Check your logs for the job. I had a problem copying the image FROM a 3550 using RME 4.0. My logs showed that RME was looking for the image at the root of the file system when the actual iamge was in a subdirectory.So check your logs and you may find...
I have also run into the same problem. RME4.0 is trying to rcp the image file using tftp. It knows the image file name (or atleast thats what the log shows) but when trying to retrive the image from the switch it does not realise that the image is av...
Thanks Patrick.... This is just to let you know that I have been trying to rate your reply with a "4" - but for some odd reason the page does not register my vote.Thanks again,Raghu
Hi,You need to use the "static" command instead of "NAT". Note that you will have to use ACLs with the static command to set inbound connections.static (RG,Internet) xxx.xxx.xxx.xxx 10.244.12.20 netmask 255.255.255.255static (RG,Internet) xxx.xxx.xxx...
