Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
posted below is the output from the post. I then receive an output stating. !!! WARNING: The switch is not usable !!!I searched on google and on ciscos site for information even on ILP Controller and nothing comes back.... any suggestions?The system...
Does cisco offer a solution in the form of a mobile wifi device, or software for one, that will "scan" and locate wireless devices, whether it's a Access Point or a laptop(rouge or deployed)?if not do you know of a company that does?Rick
if i recall it's around 120ms for voice and for data it depends on your application, but i think it's around 200 or less. Should definitely be less on the lan.
Thanks for your reply. the switch will not pass POST so i can't connect via ip to anything, only got the console port to work with. I got the xmodem copy working.
i have an adsl line that i want to set up the bandwidth for. i currently set the bandwidth of the interface to the higher of the two speed (download) to monitor the load on the interface. I would like to have the load represent that actual percenta...
