Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
l.s.I suspect one of my controllers to have a faulty battery which has to be replaced, in the pricing tool i cannot find a replacement part number. can anyone enlighten me on where to find this?Thanx in advanceFrans Verschoor
Hi,Hope this sounds familiar to someone.My conrollers run with snmp v3 user only, and seem to lose their snmpsettings after a reload of the controller.Does anyone experience the same here, and is there a solution to this annoying problem?thanx in adv...
L.s.Why is there a undeletable Mesh template on my controllers?since upgrade to latest version of WCS and controller-SW (3750+wlc) (wism) i have on 2 of my controllers a mesh tmpl.when i try to remove wcs tells me that's not possible.tried to do it d...
I have deployed a distributed lwapp wlan solution across 5 locations, which consists of a WISM and 5 3750+wlc a WCS and 180 odd AP,s (most of them 1240AGWLC's are all running 4.0.179.11 software.I have Ap authorization enabled on all of them, when i ...
My distributor told me i had to upgrade the memory of my Sup720's to accomodate the Wism Blade in my 6513. I can't seem to find any documentation on that.Could anyone point me to that information, or tell me my distributor is Defective Thanx in Adva...
Have tested roaming with some Rim devices and works fine.have not tested with critical stuff like voice or video yet.what do you mean with signal bouncing?own ap's detected as rogues?
Alas, this did not resolve my problem, i replicated the "device is unreachable" fault, rebooted the machine. the faulty controller stayed in the forementioned state after the reboot, was only revivable by removing the snmpv3 user on the controller an...
Well i just hope this is enough to open a TAC case, i cannot open one myself but next week i will ask my Cisco reseller to open one, i will keep you posted here.greetings Frans
