Mesh Profile

[snarf65]

L.s.

Why is there a undeletable Mesh template on my controllers?

since upgrade to latest version of WCS and controller-SW (3750+wlc) (wism) i have on 2 of my controllers a mesh tmpl.

when i try to remove wcs tells me that's not possible.

tried to do it directly on the controller, but off-course that's not possible.

when i see clients trying to connect to 802.11b wlans there is a "Mesh_Profile" which i didn't create.

Any lights?

Regards Frans Verschoor

[DigitalAirWireless]

Hi Frans,

the reason that you might be seeing a standard mesh template is for the 1500 series mesh AP's. Cisco have built in a few future feature into the software of which some do nothing. (Page 9 for "new mesh features" of the software release notes) also For example in the latest version version 4.1.171.0 of the controller it now references 802.11n access points. (Cisco statement page 9 - 802.11n radios are not supported for use with controller software release 4.1.171.0. These radios will be supported in a future controller release. In this release, please disregard any 802.11n-related parameters

that appear on the controller GUI pages and any 802.11n-related controller CLI commands.)

Hope that helps

Cheers Mark

*Pls rate all usefull posts