I have a 1-port VLAN that I wish to regulate the data rate on. So far, this is what I have:-1 Permit-All ACL that is always on attached to the inbound and outbound of the VLAN (not the port)-1 class matching on that ACL-1 Aggregate policer configured...

Is the rate-limit command supported in IOS ver 12.1 on the 3750 switch? If so, is there a place in the Network Assistant to configure this or only available from the console?Thanks in advance!

Hi All,I have a 3750 VLAN'ed but would like to restrict the aggregate datarate of a couple of the VLANs to specific rates (i.e. 33MB). Can someone suggest ways in which they have done this or heard of it being done?Thanks in advance!

Hi All,I have a 3750 vlan'ed but need to reduce the speed of a single port below 10mb...what is the best way to regulate the throughput of a single port when a specific rate is needed (i.e. when the max desired throughput is not 10mb or 100mb)?Thanks...