Anyone know how i can get this version or greater?

I have 2 3825 w/T3 network module cards on each end of a point to point T3. Ive gone back and forth with our provider (they've tested intrusively, etc)& and Cisco tac. Tac looked at the configuration of the router and said it was fine. However it ...

I have 2 new 3825 model routers with a T3/E3 network module card, in each, on a point to point link. The point to point link is up and running over the serial interface. Both routers are talking via pings/traceroutes from each router. Router A Ser...

This is a 1st time setup so bare with me. I have a 1700 model router that i am installing on a newly installed T1 line. I have configured the IP address, Subnet, Line speed/coding, and framing parameters on the serial interface of the router. My f...