Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
on show boot-command i found an entry called "auto upgrade path". what stand it for?Switch#sh bootBOOT path-list : flash:/ies-lanbase-mz.122-55.SE5/ies-lanbase-mz.122-55.SE5.binConfig file : flash:/config.textPrivate Config file : flash:...
i have some ME-3600x. some of version 12.2 and one of version 15.5. te last one hast same config as all other. but if i check for rstp it sends #sh spanning-treeNo spanning tree instance exists.i know abount global config commands:spanning-tre...
my environment:IE-3000-8TC industry-switchios: ies-ipservicesk9-mz.150-2.SE2if i dovlan 12name NextVLANstate active in putty, everything is ok. but if i set this lines in a config-file and use them by config net or copy tftp: running-config, then thi...
i got two ME 3600X and made primary setup on console.now i would like to switch further configuration from network assistant or embedded device manager.http is enabled ip http secure-server as wellon browser i see after logon a short page with some ...
Hi Josephit's a real interestig presentation.it confirms as i expected. it is possible. but i'm not familar with EEM-scripting. may be it's possible to get as hort sample many thanksHeiko
fine. you've tried to reproduce my casse? from theory it seems to be easy. but in real life ... it's a bit tricky. it does not work.thanks for ideasHeiko
a try to make it simple. ich i connect a new switch first time. I would like to send them a default config file (this is trivial) and of course the right image. but cisco delivers with different old versions and most are on 12.2 an below. so i dont ...
thank you for this copied parts. but i know already about. if you had read my first post, you would know about version and type of switch.VTP mode is unchanged during all of my tests at server. but there are different results from doing same input by...
to make sure that everybody can regognize, i send a complet log from console:1. try to configure vlan from cfg-file by copy tftp: running-config++++++++++++++++++++ session +++++++++++++++++++++++++Switch#sh vlanVLAN Name ...
