Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are wanting to implement Unity, however are concerned about Disaster Recovery. We have multiple locations and if we place a Unity servers at each location it will be quite costly. However, if we place one or two Unity servers in a single locatio...
I have a PIX501 plugged into a network jack in a hotel, kind of a remote war room situation. The hotel's hospitality authentication solution requires a PC to access a web-page to authentication prior to giving it access to get out to the internet. ...
I am upgrading the MCU from Vers. 2.2 and the GWY module from Vers 1.1 to 3.2Plus at least, however both have failed. On the MCU, we upgraded one step at a time, we were successful to 2.7, however failed when upgrading to 3.2. It seems we ran out o...
My IPVC-3540-MC03A module in my IPVC 3544 lost communication to my network. I consoled into it and all I am seeing is the below message over and over:"interrupt: panic: netJobAdd: ring buffer overflow!"It will not even allow me to use the help comma...
We have the same type of scenario and we use Cisco IPVC3540(w/EMP module, Audio transcoder module and a Gateway module), a 3620 router as a Gatekeeper and Polycom VSX7000 set top endpoints. The Gateway module allows for PRI VCs outside the network. ...
We simply did not have enough flashmem. Apparently on the older IPVC MCU's, they came with a smaller amount of flashmem then the MCU's running 3.x. Now I believe this is only on the original 1st Generation IPVC's and after Cisco had been using the ...
